Investing thermo-fluidic performance of si-based embedded microchannels-3D manifold cooling system for high power density electronic applications
Abstract/Contents
- Abstract
- High performance and economically viable cooling solutions must be developed to reduce weight and volume, allowing for a wide-spread utilization of hybrid electric vehicles. However, the continued drive for higher device and packaging densities has led to extreme heat fluxes on the order of 1 kW/cm2 that requires aggressive microchannel cooling strategies in order to maintain the device junction temperature ~ 200 C. The traditional embedded microchannel cooling heat sinks suffer from high pressure drop due to small channel dimensions and long flow paths in 2D-plane. Utilizing direct "embedded cooling" strategy in combination with top access 3D-manifold strategy reduces the pressure drop by nearly an order of magnitude. In addition, it provides more temperature uniformity across large area chips and it is less prone to flow instability in two-phase boiling heat transfer. This dissertation presents a series of studies to develop an effective microchannel-based heat exchanger with a fluid router system, the Embedded Microchannels-3D Manifold Cooler (or EMMC). The overall microfabrication efforts for the EMMCs are presented. The configuration of the target EMMC design is introduced and two major fabrication challenges are discussed. For single-phase flow, thermo-fluidic behavior of the EMMC is experimentally examined and validated by a conjugate numerical simulation model. DI water and R-245fa are used as working fluids and the maximum heat transfer rate of 100 kW/m2-K was measured with DI water. Furthermore, the conjugate numerical simulation modeling is heavily used to predict the geometric effect on the thermo-fluidic performance of different EMMCs and used to develop correlations to predict friction factor and Nusselt number of the system. For two-phase flow, forced-convective subcooled boiling is confirmed by the experiments and a systematic trial to calculate exit vapor quality has been made based on a few assumptions. The highly pressurized subcooled boiling delays onset-of-nucleate boiling in the microchannels and this strong condensation effect allows the EMMC to remove higher heat fluxes with low void fraction inside of the channels. The present research motivates further study into flow visualization and different types of boiling heat transfer. The better understanding to the underlying physics of the EMMC will be a key to develop more effective heat exchanger design for high-power density applications
Description
Type of resource | text |
---|---|
Form | electronic resource; remote; computer; online resource |
Extent | 1 online resource |
Place | California |
Place | [Stanford, California] |
Publisher | [Stanford University] |
Copyright date | 2020; ©2020 |
Publication date | 2020; 2020 |
Issuance | monographic |
Language | English |
Creators/Contributors
Author | Jung, Ki Wook |
---|---|
Degree supervisor | Goodson, Kenneth E, 1967- |
Thesis advisor | Goodson, Kenneth E, 1967- |
Thesis advisor | Asheghi, Mehdi |
Thesis advisor | Senesky, Debbie |
Degree committee member | Asheghi, Mehdi |
Degree committee member | Senesky, Debbie |
Associated with | Stanford University, Department of Mechanical Engineering. |
Subjects
Genre | Theses |
---|---|
Genre | Text |
Bibliographic information
Statement of responsibility | Ki Wook Jung |
---|---|
Note | Submitted to the Department of Mechanical Engineering |
Thesis | Thesis Ph.D. Stanford University 2020 |
Location | electronic resource |
Access conditions
- Copyright
- © 2020 by Ki Wook Jung
- License
- This work is licensed under a Creative Commons Attribution Non Commercial 3.0 Unported license (CC BY-NC).
Also listed in
Loading usage metrics...